Rapid City winters leave driveways gray with salt, grime, and tire marks, and summer adds dust and oil. A surface-cleaner pass brings concrete back to an even, bright finish. Here is what driveway and concrete cleaning costs in the Rapid City area and what to expect.
Driveway and concrete cleaning in the Rapid City area typically runs about $150 to $400. What moves the number:
We quote flat by the job after sizing it up. Request a quote and let us know the approximate area and any tough stains.
Flat concrete is cleaned with a rotary surface cleaner, not a wand — that is what delivers a consistent, stripe-free result instead of the "zebra stripes" a bare pressure wand leaves. We pre-treat oil and organic staining with a degreaser, run the surface cleaner at the right pressure for the concrete, then rinse the edges and any detail work by hand. Unlike your siding, concrete is a hard surface built to take that pressure, so it comes out bright without damage.
Between de-icing salt, sand, and freeze-thaw cycles, Rapid City concrete takes a beating each winter, and Black Hills dust and pollen settle into the surface all summer. That build-up is slick when wet and locks in stains if it sits. A cleaning in late spring resets the driveway for the year, and many homeowners pair it with a house soft wash or deck and fence cleaning in the same visit.
Usually $150 to $400 depending on square footage, staining, and whether walkways or a patio are added.
Yes — degreasers and a surface cleaner lift most oil, salt, and grime; very old soaked-in oil may lighten rather than vanish.
No. Concrete is a hard surface meant for higher pressure; we use a surface cleaner for an even, stripe-free finish.
Cleaning is the first step; ask about the surface and we can advise on timing if you plan to seal.
Visit the full FAQ page for more.
Soft wash siding to match the fresh driveway.
Clean and prep wood surfaces for stain.
Sidewalks and lots for local businesses.
You can also review roof soft washing, gutter brightening, and the areas we serve.